Thursday, August 18, 2016

Phone stand

There are times you just need to stand.
Well, my phone does, anyway.



This was a 30 minute print.  I just needed something to stand my phone on, and found this on Thingiverse.  It folds very small, and has a hole for a key chain.

I haven't been printing much as I've been distracted by not being in the office, so I'm guessing it's time for another calibration.  The bottoms are a little rough, and not completely filled in, and the pin that printed with the sides, well, didn't really.  It tried to print half of the pin before it degraded into some fuzzy nuclear accident.  I replaced that part with a round toothpick I wrapped in several layers of scotch tape, which works really well.

No comments:

Post a Comment